ll 8 STEERING r Turn Signal Continued Condition Possible Cause Correction TURN SIGNAL 1 Broken lane change pressure 1 Replace switch WILL NOT INDICATE pad or spring hanger LANE CHANGE 2 Broken missing or misplaced 2 Replace or reposition as lane change spring required 3 Jammed base or wires 3 Loosen mounting screws reposition base or wires and retighten screws 25 in lbs TURN SIGNAL 1 Foreign material or loose parts 1 Remove material and or parts WILL NOT STAY impeding movement of yoke IN TURN POSITION 2 Broken or missing detent or 2 Replace switch cancelling springs 3 None of the above 3 Replace switch HAZARD SWITCH 1 Foreign material between 1 Remove foreign material CANNOT BE hazard support cancelling a No foreign material impeding TURNED OFF leg and yoke function of hazard switch replace tum signal switch HAZARD SWITCH 1 Loose switch mounting screws 1 Tighten mounting screws WILL NOT STAY ON 25 in lbs OR DIFFICULT TO TURN OFF 2 Interference with other com 2 Remove interference ponents 3 Foreign material 3 Remove foreign material 4 None of the above 4 Replace switch NO TURN 1 Defective or blown fuse 1 Replace fuse SIGNAL LIGHTS 2 lnoperative tum signal flasher 2 Replace tum signal flasher 3 Loose chassis to column 3 Connect securely connector 4 Disconnect column to chassis 4 Replace signal switch connector Connect new switch to chassis and operate switch by hand If vehicle lights now operate normally signal switch is inoperative 5 If vehicle lights do not operate 5 Repair chassis wiring as required check chassis wiring for opens grounds etc sossac